1963 ORD NO 1171 - Laserfiche WebLink

Browse Search

5 0 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 2E 2? 2E 29 3C 31 3� separates an "ML" Zone from any "R" Zone. (SECTION 914): REAR YARD (3) A rear yard having a depth of not less than twenty feet, except that a minimum rear yard of fifty feet shall be required whenever a lot or parcel of land in the r'ML" Zone abuts a lot or parcel in any "R" Zone or abuts any street or alley which separates an "ML" Zone from any 11" Zone., (SECTION 915): LANDSCAPINGw Front yard areas and street side yard areas as required in this section„ shall be suitably landscaped with plant materials, adequately maintained and in no instance shall be used for off-street parking, loading, storage or access- ory ccess-ory buildings. (SECTION 915„ 1)o USE OF REAR AND SIDE. YARDS FOR OFF-STREET PARKING, STORAGE, ETC,* Rear yard areas and interior side yard areas, as required in this article, may be used for off --street parking, loading, outdoor storage of materials or equipment; provided, however, that no accessory building may be located on such required yard areas. (SECTION 916): PARKING REQUIREMENTS, Parking area shall be provided in Manufacturing Limited Zones as required in the provisions of Section 1406 through 1410 of this ordinance,, (SECTION 917): WALLS„ Whenever a lot or parcel in any "R" Zone backs to or is separated by an alley from a lot or parcel in the "ML" Zone, a six foot high solid masonry wall shall be constructed along the property line separating the "R" Zone from the "ML" District or along the alley right of way line on the "ML" side of such alley. Such wall shall not be required until the lot or parcel is occupied by a permitted uses, (SECTION 918): METAL BUILDINGS, No metal buildings, as defined in the Bulding Code of the city., or any other building of which the walls or walls and roof are composed of sheet metal shall be erected., constructed., established, altered., enlarged., moved into or within a manufacturing limited zone. (SECTION 919): AREA Area requirements in a manufacturing limited zone shall be as follows: (A) LOT AREA AND WIDTH* (1) Lot Area. A Minimum area of one acre; except, that a lot having less area may be approved in connection with uses permitted under a condit- ional use permit. (Z) Lot Width. A Minimum frontage of one hundred fifty feet; except, that a lot having less width may be approved in connection with uses permitted under a conditional use permit. (SECTION 920): SIGNS The following signs shall be permitted in the "ML" Zone: